KAEL Muhendislik Elektronik TC - PT100 Manual page 6

activating the Fault Setting function in Settings.
NOTE: Exceeding the minimum / maximum scale value can result from interference in the sensor
lines; In this case, the sensors and all extension cables must be installed correctly. (See the
Measurement Signal Transfer paragraph)
Data Recording Error
If the internal memory fails, the FAULT relay position changes and the main display shows
warning. You can press the resulting
the most recently programmed parameters remain the same and can not be changed.
To check if the memory is working properly, turn off the device and turn it on again. If the same
error is encountered, send the device to KAEL Mühendislik Ltd. to be reapired.
COMISSIONING
1. Step: Choice Of Language
Up, Down buttons to select one of the Turkish, English or Russian
language and press Set button. After the language option is stored in
the memory, the device starts to work on the selected hotplate and
then goes to the 2nd step Temperature setting section.
2. Step: Selection Of Temperature Unit
temperature units Celcius (ºC) or Fahrenheit (ºF) is selected and the
Apply button is pressed. In this case, if OK is pressed, the change is
recorded. If you want to change it, press the Back key
3. Step: Channel 4 (ch4) Operating Status
set to On (running) or Off (disabled), and it will be set to work and
then the Apply button will be pressed. In this case, if OK is pressed,
the change is recorded. If you want to change without recording,
press Back button.
Refer to section 3.7 SETTING FAULT SETTING for the error that will occur as a result of
11/10/2016 14:25
85
ch1
83
ch2
84
ch3
32
ch4
Menu
The next screen will appear when it is first activated.
With the Up and Down buttons on the bottom line, one of the
By using the Up, Down arrow buttons, the 4th sensor will be
Reset button to remove the fault from the screen.In this case,
ºC
ºC
Eeprom Err
ºC
ºC
Rapor
FAN Reset
11/10/2016 14:25
LANGUAGE SET.
English – Pyccкйй – Türkçe
English
Set
11/10/2016 14:25
TEMPRATURE SET.
Select Temprature Unit
ºC
Apply
11/10/2016 14:25
CHANNEL 4 SET.
Channel 4 (ch4)
OFF
Apply