Brother MFC-240C User Manual page 106

Error Message Cause
The machine is out of paper or
No Paper Fed
paper is not properly loaded in the
paper tray.
The paper is jammed in the
machine.
The number you dialled does not
No
answer or is busy.
Response/Busy
You tried to access a Speed Dial
Not
number that is not programmed.
Registered
The machine's memory is full.
Out of Memory
Paper is jammed in the machine.
Paper Jam
Print Unable XX The machine has a mechanical
problem.
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
Scan Unable XX The machine has a mechanical
problem.
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
Paper is not the correct size.
Wrong Paper
Size
A non-PictBridge compatible or
Wrong USB
broken device has been connected
device
to the PictBridge port.
96
Action
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Colour Start.
Remove the paper and load it again and then
press Mono Start or Colour Start.
See Printer jam or paper jam on page 98.
Verify the number and try again.
Set up the Speed Dial number. (See Storing
Speed-Dial numbers on page 48.)
Fax sending or copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
Printing operation in progress
Reduce print resolution. (For details, see
®
Printing for Windows or Printing and Faxing for
®
Macintosh in the Software User's Guide on the
CD-ROM.)
See Printer jam or paper jam on page 98.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 97 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 97 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Load the correct size of paper (Letter, Legal or
A4), and then press Mono Start or Colour Start.
Unplug the device from the PictBridge port, then
press Power Save to turn the machine off and
then on again.