Epson SC-S60600 Series Operator's Manual page 13

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
R
Hold the center of the media in one hand, and
pull it straight until it is aligned with the bottom
edge of the label on the after heater.
Do not pull the media with both hands. This
could cause the media to skew or move around.
S
T
Tap lightly on both ends of the media, and check
if there is a difference in tension between the left
and right sides.
Basic Operations
If there is a difference in tension, the media
becomes loose.
From the front of the printer, raise the media
loading lever, and correct the looseness in the
media.
Once the looseness is corrected, lower the media
loading lever.
U
While holding the tabs of the media edge plates
on both sides, move the plate to the edge of the
media.
Adjust so that the edges of the media are aligned
with the center of the round holes in the media
edge plates.
13