Select Devices - Honeywell VISTA-ICM Installation And Setup Manual

VISTA-ICM Installation and Setup Guide

Select Devices

The Device Setup page allows you to configure what specific equipment is controlled by
each VISTA-ICM in the network. Select the device controlled by each VISTA-ICM
before configuring anything else in the system. The device selection process is
performed using the following steps:
Click on Devices to bring up the Device Setup Node List page as shown in figure 5. This
page contains a list of all the devices in the system. The checkbox on the left side of the
page will contain a green checkmark for each device that has already been set up. Click
on the name of the first device in the list that has not been configured.
Figure 5 - Device Setup Node List
7