Configuring The Vista-Icm; Connecting To The Vista-Icm Setup Web Pages; Vista-Icm Leds - Honeywell VISTA-ICM Installation And Setup Manual

Configuring the VISTA-ICM

Connecting to the VISTA-ICM setup web pages

Once the network hardware is in place, you can initiate communication with the VISTA-
ICM hardware. Use a PC or a tablet to connect to the VISTA-ICM web pages. To
connect to the VISTA-ICM, take the following actions:
1. Make sure the Vista VISTA-ICM is powered on by checking to see that the Power
LED is illuminated. Give the VISTA-ICM at least 60 seconds to boot up and obtain
an IP address from the router.
2. Open the web browser on the computer, and in the Address bar enter:
http://honeywell/setup
3. This will open the VISTA-ICM setup start page. Configure the VISTA-ICM
according to the instructions in the next section.

VISTA-ICM LEDs

The VISTA-ICM has three LEDs as follows:
•
STATUS (located nearest the ECP connector) – Blinks when the device has activity.
•
ETHERNET LINK (located in the middle) – Flickers when there is internet activity.
•
POWER (located on the outside edge of the PCB) – Lit when power is applied to the
VISTA-ICM.
VISTA-ICM Installation and Setup Guide
5