Installing The Thermostat Cover Lock - Johnson Controls METASYS TEC1100 Series Technical Bulletin

Point Name
(Cont.)
Y1 State
Y2 State
G State – Fan
ac
Temp Units
b
Wrench BI
b
Temp Alarm
b
Filter
Notes:
a Commandable
b Can be a COS alarm to the BAS or NDM to initiate a dial-out.
c On the Metasys NCM system, map BD9 Temp Units Mode as a Binary Output (BO) object in a Control System
(CS) object with Autorestore and Local Control set.
The Controller Point Type is the fixed point definition inside the controller. The CPN/FAC point is the software point
definition inside the Companion software. The BAS Model Point type is the definition inside the model file. An NCM
CS object must be used to retrieve the data.
Control of the Analog Data (AD) objects is the last command received is the one that controls the thermostat. For
example, if the Metasys system sends a Night override, but the occupant selects Day mode, the TEC goes into Day
mode.
Installing the
Thermostat
Cover Lock
TEC N30 BAS
Point (CPN/ Model
Type/ FAC) Point
Addr. Object Type
Type
BD-6 N2 BI CSBD BD6
(BI)
BD-7 N2 BI CSBD BD7
(BI)
BD-8 N2 BI CSBD BD8
(BI)
BD-9 N2 BO CSBD BD9
(BO)
BI-1 N2 BI CSBI BI1
(BI)
BI-2 N2 BI CSBI BI2
(BI)
BI-3 N2 BI CSBI BI3
(BI)
To install the thermostat cover lock:
1. Place the ends of the lock piece (included with unit) under the lock
pins extending from the bottom of the mounted base. The tab in the
middle of the lock piece extends downward from the mounted base
(Figure 13).
2. Press the lock piece up and into the base while gently prying open the
thermostat to release the lock. Use caution to avoid cracking the
thermostat base or cover.
Override Range
0 = Off, 1 = On
0 = Off, 1 = On
0 = Off, 1 = On
0 = °C, 1 = °F
0 = Normal, 1 = Alarm
0 = Normal, 1 = Alarm
0 = Normal, 1 = Alarm
TEC1100 Series Thermostat Technical Bulletin
TEC TEC TEC
1101 1102 1103
Cool 1 Comp 1 Cool 1
Comp 2 Cool 2
♦ ♦ ♦
♦ ♦ ♦
♦ ♦
♦ ♦ ♦
♦ ♦
17