Troubleshooting Suggestions - Wells B40 Owner's Manual

SYMPTON
Won't heat - - no indicator lights
One or more section won't
heat—or not hot enough
One or more section too hot
Element assy loose, or difficult to
raise or lower
Element assy does not latch in up
position
POSSIBLE CAUSE
Not plugged in, or
Circuit breaker tripped.
Temperature control not set
240V unit run on 208V
Damaged component or wiring
Temperature control not set
208V unit run on 240V
Damaged component or wiring
Damaged hinge
(see page 7 for precautions)
Damaged support rod assembly
11

TROUBLESHOOTING SUGGESTIONS

SUGGESTED REMEDY
Check plug
Check / reset circuit breaker
Set temperature control knob to desired temperature
Verify proper voltage
Contact an Authorize Wells Service Agency for
repairs
Set temperature control knob to desired temperature
Verify proper voltage
Contact an Authorized Wells Service Agency for
repairs
Contact an Authorized Wells Service Agency for
repairs
Contact an Authorized Wells Service Agency for
repairs
There are no user-serviceable
components in this unit.
In all instances of damage or
malfunction, contact your
Authorized Wells Service
Agency for repairs.