Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Page 2
492-2782, for information and other details concerning if service is performed by unauthorized personnel. The warranty. prices charged by Wells Mfg. Co. for its products are based SERVICE POLICY AND PROCEDURE GUIDE ADDITIONAL WARRANTY EXCLUSIONS Resetting of safety thermostats, circuit breakers, over cleaning schedules, are customer responsibility.
Page 3
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing Co. appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
Do not operate this appliance if the control panel is damaged. Do not operate this appliance if a temperature control knob is missing. Call CAUTION: your Authorized Wells Service Agent for service. HOT SURFACE The technical content of this manual, including any wiring diagrams,...
Page 6
Failure can SETUP result in personal injury and The WRG-Series Hot Dog Roller Grill is designed to set on top of the property damage. matching WBC-Series Hot dog Bun Cabinet. Otherwise, set the appliance only on a firm, level, non-combustible surface. Verify local WARNING: codes for requirements.
Page 7
OPERATION Plug the appliance into an appropriate receptacle. Press the POWER CAUTION: SWITCH to "ON". The lighted switch will glow. HOT SURFACE Temperature control is by INFINITE SWITCH. The knob position is an Exposed surfaces indication of the temperature, where higher numbers indicate higher can be hot to the touch and temperature.
CLEANING INSTRUCTIONS PROCEDURE: Clean Hot Dog Roller Grill DANGER PRECAUTIONS: Rollers are best cleaned while warm. Turn ELECTRIC SHOCK HAZARD control to "3" and allow to cool for 20 minutes. Wear heat resistant gloves while cleaning rollers. FREQUENCY: Daily (minimum) or: Every 3-4 hours during heavy traffic periods or when used for high sugar or high fat product.
TROUBLESHOOTING SUGGESTIONS SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY No power to appliance Circuit breaker off or tripped Reset circuit breaker Power cord damaged or unplugged Inspect, repair or plug into appropriate receptacle as req'd Power switch "OFF" Press power switch to "ON" Power switch damaged Replace switch Appliance does not heat...
PARTS LIST ITEM DESCRIPTION WRG-20 WRG-30 WRG-50 CABINET ASSEMBLY SIDE PANEL BOTTOM PANEL RETAINER, ELEMENT LEFT SIDE RETAINER, ROLLER RIGHT SIDE DRIP TRAY 22985 22986 22987 OVERLAY, FRONT PANEL DECAL 505947 505948 505949 POWER SWITCH 81756 81756 81756 KNOB, TEMPERATURE CONTROL 505950 505950 505950...
For factory authorized service, or to order factory SNEEZE GUARD FOR WRG-50 22959 authorized replacement DRIP TRAY, 17" FOR WRG-20 22985 parts, contact your Wells authorized service agency, DRIP TRAY, 24" FOR WRG-30 22986 or call: DRIP TRAY, 36" FOR WRG-50 22987 Wells Manufacturing Co.