Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking Unless otherwise specified, all commercial cooking The prices charged by Wells Bloomfield for its products The prices charged by Wells Bloomfield for its products equipment manufactured by WELLS BLOOMFIELD, LLC is are based upon the limitations in this warranty.
INSTRUCTIONS POUR LE NETTOYAGE CONSEILS POUR LE DÉPANNAGE INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance. Thank You for purchasing this Wells Bloomfield appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
FEATURES & OPERATING CONTROLS GRATE - NORMAL POSI TI ON GRATE - RAI SED POSI TI ON SPL ASH GUARD GREASE DI SCHARGE CHUTE GREASE TROUGH ADJ UST ABLE W ATER PAN CONTROL KNOB GAS PRESSURE “ OFF” POSI TI ON REGULATOR CONTROL KNOB “...
Exposed su off all gas supply valves and move to a remote location to call your to the touch and may cause Authorized Wells Service Agent for service. burns. The technical content of this manual, including any parts breakdown illustrations and/or adjustment procedures, is intended for use by qualified technical personnel only.
For servicing, warranty on this charbroiler is Wells Mfg. recommends 6” clearance from rear of the appliance to wall. in effect only when the griddle Install adjustable legs, one on each corner of the appliance, in the is installed in accordance with holes provided.
Page 7
INSTALLATION (continued) GAS APPLIANCE CODE COMPLIANCE GAS APPLIANCE CODE COMPLIANCE DANGER: The installation of gas piping from the outlet side of the gas meter or FIRE AND service regulator to the charbroiler must be performed by a technician EXPLOSION qualified and certified or licensed to install gas-fired equipment. HAZARD A licensed and qualified technician must perform the initial startup and NEVER use an open flame to...
Page 8
INSTALLATION (continued) DANGER: INSTALLING THE GAS GRIDDLE FIRE AND Refer to the nameplate. Verify the fuel type and pressure, which must EXPLOSION match the nameplate specifications. Connecting the hotplate to the HAZARD wrong fuel type and/or pressure will compromise the safety and/or NEVER use an open flame to performance of the appliance.
Page 9
Adjust the pilot flame to 1/4” high. Test for operation: all sections Authorized Wells Service of the burner must light without undue delay. Drafty conditions may Agency. require a higher flame to allow the pilot to remain lit.
The burner control knobs must be turned by hand only. Never use tools to turn the control knob. If the knob will not turn by hand, DO NOT attempt to force or repair it. Contact your Authorized Wells In the event a gas odor is Service Agency for repairs.
Page 11
Be sure the pilot light is lit before operation. See Lighting the Pilot repair a stuck control valve. Light, page 8. Contact your Authorized Wells The burner control knobs must be turned by hand only. Never use Service Agency for repairs.
CLEANING INSTRUCTIONS PREPARATION WARNING: Turn both temperature control knobs OFF. FIRE HAZARD Allow broiler to cool completely. Shut off the gas supply valve Shut off the Disconnect broiler from electric power. before cleaning. FREQUENCY CAUTION: Daily. BURN HAZARD Allow broiler to cool Allow broile TOOLS completely before cleaning.
Page 13
CLEANING INSTRUCTIONS (continued) PREPARATION PREPARATION WARNING: Turn gas shut-off valve OFF. FIRE HAZARD Allow broiler to cool before cleaning. FREQUENCY Shut off the gas supply Shut off t As Needed valve before cleaning. TOOLS Plastic Scouring Pad, Soft-Bristled Fiber Brush Clean Cloth or Sponge Mild Detergent Cleaner Formulated for Stainless Steel...
Contact Authorized Wells Service burner or other internal Agency for repairs component NOTE: There are no user serviceable components in the burner assemblies or in the control valves. In all cases of damage or malfunction, contact your Authorized Wells Service Agency for repairs.
LEGS, ADJ USTABLE 4” METAL (SET of 4) 2A-Z0314 For factory authorized service, BRUSH, BROILER 2P-30013 or to order factory authorized replacement parts, contact your Wells authorized service agency, or call: Wells Bloomfield, LLC 10 Sunnen Dr., St. Louis MO 63143 USA Service Dept. phone: (314) 678-6314...
EXPLODED VIEW & PARTS LIST LA VUE EXPLOSEE & LES PARTIES ENUMERENT HDCB- SERIES HEAVY-DUTY GAS CHAR-BROILER SERVICE COMPONENTS COLLECTION -HDCB GRI L AU GAZ COMPOSANTS DISPONIBLES 6” REGULATOR CONVERTIBLE GRATE WS-23222 FOR LP OR NAT GRI LLE DE CUI SSON W S-23222 2J -306629 RÉGULATEUR FUEL MANIFOLD (reference)
Page 18
Des guides supplémentaires sont disponibles chez votre distributeur Wells. Ce guide doit être lu et compris par toutes personnes installant ou utilisant cet appareil. Contacter votre distributeur Wells pour toutes questions au sujet de l’installation, du fonctionnement ou de l’entretien de cet appareil.
INFORMATIONS CONCERNANT LES AGENCES INSTALLATION FONCTIONNEMENT INSTRUCTIONS POUR LE NETTOYAGE CONSEILS POUR LE DÉPANNAGE INTRODUCTION Merci d’avoir acquis cet appareil Wells Bloomfield. L’installation correcte, le fonctionnement Me i d’ is et eil Well Bl mfield. L’i tallatio te le f ctio professionnel et l’entretien régulier de cet appareil assureront ses meilleures performances et sa...
FONCTIONNALITÉS ET COMMANDES GRI LLE POSI TI ON NORMALE PROTECTI ON CONTRE LES ÉCLABOUSSURES GRI LLE POSI TI ON HAUTE TRAPPE D' ÉVACUATI ON DE LA GRAI SSE BAC POUR LA GRAI SSE PI EDS RÉGLABLES LÈCHEFRI TE BOUTON DE RÉGULATEUR DE COMMANDE PRESSI ON DU GAZ...
Ne pas utiliser cet appareil en présence d’une odeur de gaz. Fermer corporels et la mort. Ne pas tous les robinets à gaz et se rendre dans un lieu éloigné pour appeler un technicien d’entretien agréé par Wells. faire fonctionner l’appareil si ses pieds ne sont pas La partie technique du présent manuel, y compris tous les schémas...
L’INSTALLATION DÉBALLAGE & INSPECTION REMARQUE : NE PAS jeter le carton ni les autres matériaux Sortir l’appareil du carton avec précaution. Enlever tous les films de d’emballage jusqu’à ce que protection en plastique, les matériaux d’emballage et les accessoires l’appareil ait été inspecté pour la de l’appareil avant d’entamer toute procédure d’installation et de détection de vices cachés et ait connexion.
Page 23
L’INSTALLATION (a continué) CONFORMITÉ AU CODE RELATIF AUX APPAREILS À GAZ CONFORMITÉ AU CODE RELATIF AUX APPAREILS À GAZ DANGER : L’installation des tuyauteries du gaz entre le côté sortie du compteur Danger à gaz ou du régulateur de l’alimentation publique et l’appareil doit être d’incendie et d’...
Page 24
L’INSTALLATION (a continué) DANGER : INSTALLATION DU GRILL À GAZ DANGER Consulter la plaque signalétique. Vérifier la nature et la pression du D’INCENDIE ET D’ combustible, qui doivent correspondre aux spécifications indiquées sur la D’EXPLOSION D’ plaque signalétique. Le raccordement de l’appareil à une alimentation en combustible incorrecte ou sous pression incorrecte compromettrait la sécurité...
Page 25
à une altitude l’unité en service . de plus de 660 mètres (2 000 pieds), veuillez contacter votre L'AJUSTEMENT DE RÉGLAGE DE distributeur agréé Wells. FLAMME OUVERTURE LA VEI LLEUSE DE BRULEUR D' ALLUMAGE MOI NS...
à la main, NE PAS essayer de le forcer ni de le gaz, mettre l’unité à l’arrêt en réparer. Pour toute réparation, contacter le distributeur agréé Wells. fermant le robinet d’arrêt Les boutons ou robinets forcés ou mal réparés posent un risque principal du gaz et contacter la d’incendie et/ou d’explosion.
Page 27
Pour toute réparation, contacter le Les boutons de commande des brûleurs ne doivent être tournés qu’à distributeur agréé Wells. Les la main. Ne jamais utiliser d’outil pour tourner les boutons. boutons ou robinets forcés ou Le bouton de commande de ce gril à gaz offre une plage continue de mal réparés posent un risque...
INSTRUCTIONS POUR LE NETTOYAGE PRÉPARATION: AVERTISSEMENT: A A VE A A A A Tourner les deux boutons de commande de température jusqu’à la DANGER position OFF (ARRÊT) D’INCENDIE D’ Laisser refroidir le gril complètement Fermer le robinet d’arrêt du Fermer le ro Débrancher le gril de la prise d’alimentation électrique gaz avant le nettoyage.
Page 29
INSTRUCTIONS POUR LE NETTOYAGE (a continué) PRÉPARATION PRÉPARATION AVERTISSEMENT: Fermer le robinet d’arrêt (sur la position OFF/FERMETURE). DANGER Laisser refroidir le gril avant de le nettoyer. D’INCENDIE FRÉQUENCE Fermer le robinet d’arrêt du Selon les besoins gaz avant le nettoyage USTENSILES Tampon de récurage en plastique, brosse à...
REMARQUE : Les ensembles de brûleur ou les robinets de commande ne comportent aucune pièce que l’utilisateur puisse réparer. Dans tous les cas de dommage ou de fonctionnement défectueux, contacter le distributeur agréé Wells pour procéder aux réparations.
Page 31
Le Service des pièces détachées peut fournir le nom et le numéro de téléphone du distributeur agréé WELLS le plus proche de chez vous. RENSEIGNEMENTS À FOURNIR AU SERVICE APRÈS-VENTE Il est recommandé d’avoir les renseignements suivants sous la main lors d’un appel pour service après-vente RESTAURANT ________________________________ ADRESSE __________________________ DATE D’INSTALLATION ________________NOM DU TECHNICIEN __________________________...
Page 32
WELLS BLOOMFIELD, LLC 10 Sunnen Dr. , St. Louis, MO 63143 telephone: 314- 678- 6314 fax : 314- 781- 2714 www. wellsbloomfield. c om...