Rack Maintenance And Care; Fit Tips; 4-Bar Link Folding Mechanism; Hitch Receiver Connection - Thule Transport T2 Assembly And Use Manual

Hitch mount bicycle rack
Table of Contents

Advertisement

Rack Maintenance and Care

1)

4-Bar Link Folding Mechanism

Periodically tighten bolts in 4 bar link on the
hitch base to ensure a stable connection.(
.) You should feel some resistance when
P
folding the rack up and down.

2) Hitch Receiver Connection

Make sure to check and tighten the anti-
wobble hitch bolts periodically to ensure a
stable connection. (
3)
Support Arm Rotation Friction
Check and tighten the plastic wingnuts
Fig A., pg 1)
The arm should rotate easily, but should not
fall under its own weight. The arm should
snap into place when stowed and should
require some effort to rotate the arm up
4)
Cleaning your rack
Frequently clean the rack of dirt and road grime including wiping down the teeth on
the support arm while extended. It is especially important to clean road salt from
the rack as this can promote rust over time.

Fit Tips

A) Pitch
Figure Q.
2)
For ground clearance issues see Accessories on page 9
3)
Retrofitting your rack to another hitch size – 1 ¼" or 2"
Swap out the hitch base with the other size by removing the bottom two hitch bolts seen
in fig P at the top of the page. For part numbers on hitch assemblies see Accessories on
page 6&7
9490-A T2 Instruction Manual
See Fig B, pg 2
at the base of the support arm.
1)
B) Offset
.
Call your dealer to purchase the proper part.
Transport T2
Hitch Mount Bicycle Rack
Assembly & Use
Fig
.)
(See
.
Bike Interference with each other or with the car.
A.
Pitch – Distance between bikes
To adjust pitch, loosen all 4 bracket bolts and slide
the tray in or out. Re-tighten bolts to secure tray
(See Step 2 on pg. 2.)
B.
Offset – Side to Side Distance
To adjust offset, loosen all 4 bracket bolts and slide
tray left or right. Re-tighten bolts to secure tray
Step 2 on pg. 2 for directions on tightening bracket bolts.)
Note: Do not slide tray past offset limit
marks on either side of the bracket or
failure may occur. See Fig D. pg 2.
.
Page 6 of 12
1) 4-Bar Link Bolts
Figure P.
.
.
(See

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sportworks transport t2

Table of Contents