Assembly Instructions - Thule Transport T2 Assembly And Use Manual

Assembly Instructions:

A) I
nsert hitch base into vehicle's hitch receiver
Fig. B.
NOTE: Assembly can be done off the vehicle
if desired. Proceed to Step 2.
B)
Tighten side hitch bolt with a
15/16" wrench to 80ft-lbs for a 2"
Hitch 40ft-lbs for a 1-¼" Hitch
C)
Tighten top hitch bolt with a ¾"
.
wrench to 40ft-lbs
D) Orange
line on
decal.
Figure C. - View from bottom of the rack stowed.
A)
Insert the two plastic caps into the holes at the
.
end of the spar tube
Fig F.
Note: This prevents water from getting
inside the spar tube.
Assembly is Complete!
9490-A T2 Instruction Manual
.
.
A)
Slide the first bike tray oriented with the front wheel
cradle on the driver's side of the vehicle onto the
backbone of the rack
B)
Position the tray so that the bracket lines up with the white
line on the bottom of the decal(
center line on the side of the tray shows through the cutout in the
.
bracket
Fig D.
C)
Tighten all 4 bolts with the 6mm
allen wrench until the lower bracket
wings touch the bottom of the spar
tube.
See Fig. D
must be tight and should be
B) Orange
periodically checked with rack use.
line on
decal.
D)
Repeat A-C with second bike
tray oriented with the front wheel
cradle on the passengers side.
Line the bracket up with the other
end of the decal
center it with the centerline mark.
Fig. D.
Page 3 of 12
Transport T2
Hitch Mount Bicycle Rack
Assembly & Use
C) Top Anti-wobble Hitch Bolt
Hitch Base
Figure B.
.
.) and center the tray so the
Fig C
These fasteners
and
(Fig C.)
Figure F
.
Vehicle Hitch
Receiver
B) Side Anti-wobble
Hitch Bolt
Figure D
.
* Be sure to tighten bolts
equally to ensure a level
carrying platform.