Out Of The Box; Tools Required For Assembly - Thule Transport T2 Assembly And Use Manual

To prepare your rack for installation...

Out of the box:

1. To prepare your rack for installation, remove the bolt, nut and washer from the rear linkage
bars using a ¾" wrench(see Fig A-1).
2. Swing the hitch base 180 degrees and line up the bushings in the middle hole with the rear
linkage bars(Fig A-2).
3. Replace the bolt, nut and washer and tighten(Fig A-2).

Tools Required for Assembly:

6mm Allen Wrench (included), ¾" wrench and a 15/16" wrench. NOTE: All fasteners are
pre-installed for easy assembly.
Fig A-1
2. Hitch Base
Fig A-2
9490-A T2 Instruction Manual
Transport T2
2. Middle hole
3. Replace Bolt,
nut and washer.
Page 2 of 12
Hitch Mount Bicycle Rack
Assembly & Use
2. Rear linkage Bars
1. Bolt, Nut and washer to
remove