Mechanical installation
3.3 Installing the Braking Module
3.3.4
Installing the Braking Module in a Power Module frame size JX
Figure 3-9
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the figures in the
diagram.
1. Insert the Braking Module.
2. Screw in the 4 retaining screws for securing the Braking Module.
3. Secure the connection clip to the DC link (DCPA / DCNA) with 2 screws (Braking Module
connection) and 2 nuts (DC-link connection).
Note
Pay attention to the tightening torques
You must observe the tightening torques. Information on this can be found in the table in the
"Mechanical installation" section
26
Installing the Braking Module in a Power Module frame size JX
Braking Module / braking resistor
Operating Instructions, 11/2017, A5E00331454A