Properties; Power Module Pm-E Dc24V Hf (6Es7138-4Ca60-0Ab0) - Siemens SIMATIC ET 200S Manual

Properties

1.1

Power module PM-E DC24V HF (6ES7138-4CA60-0AB0)

Properties
● The PM-E DC24V HF power module monitors the supply voltage for all electronic
● You can use all the electronic modules except the 2DI AC120V ST, 2DI AC230V ST, and
● The current status of the power module is stored in the status byte in the process input
● The PM-E DC24V HF power module is suitable for fail-safe modules.
● Extended temperature range from 0 to 55°C with vertical installation.
Requirements for operation
It is possible to operate the PM-E DC24V HF power module using the following interface
modules as of the order numbers specified.
Interface module
IM 151-1 STANDARD
IM 151-1 FO STANDARD
IM 151-1 HIGH FEATURE
IM 151-3 PN
IM 151-3 PN FO
IM 151-3 PN HIGH FEATURE
IM 151-3 PN HIGH SPEED
IM 151-8 PN/DP CPU
IM 151-8F PN/DP CPU
Power module PM-E DC24V HF (6ES7138-4CA60-0AB0)
Manual, 06/2010, A5E02515369-02
modules in the voltage group. The supply voltage is fed in by means of the TM-P terminal
module.
2DO AC24..230V/1A in the voltage group of the PM-E DC24V HF power module.
image (PII). This is updated irrespective of whether the "No Load Voltage" diagnosis has
been enabled.
CAUTION
If you do not maintain the indicated load voltage of 24V DC, the result may be
dangerous plant conditions.
The result may be damages to the ET 200S or minor personal injuries.
Only connect the specified load voltage of 24V DC to the TM-P terminal module of the
power module. The connected load voltage must correspond to the supply voltage of the
electronic modules in the voltage group.
as of order number
6ES7151-1AA05-0AB0
6ES7151-1AB05-0AB0
6ES7151-1BA02-0AB0
6ES7151-3AA23-0AB0
6ES7151-3BB23-0AB0
6ES7151-3BA23-0AB0
6ES7151-3BA60-0AB0
6ES7151-8AB01-0AB0
6ES7151-8FB01-0AB0
1
Firmware version (or
higher)
V2.2.4
V2.2.4
V2.2.3
V7.0.0
V7.0.0
V7.0.0
V3.0.0
V3.2.0
V3.2.0
7