3.3.3
Installing the Braking Module in a Power Module frame size HX
Figure 3-8
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the figures in the
diagram.
1. Insert the Braking Module.
2. Screw in the 4 retaining screws for securing the Braking Module.
3. Secure the connection clip to the DC link (DCPA/DCNA) with two screws (Braking Module
connection) and two nuts (DC-link connection).
Note
Pay attention to the tightening torques
You must observe the tightening torques. Information on this can be found in the table in the
"Mechanical installation" section
Braking Module / braking resistor
Operating Instructions, 11/2017, A5E00331454A
Installing the Braking Module in a Power Module frame size HX
Mechanical installation
3.3 Installing the Braking Module
25