Stator Installation; Flywheel Removal - Briggs & Stratton 950 Series Advance Product Service Information

STATOR INSTALLATION

If the engine is equipped with a stator assembly, install it as follows:
1) Position the stator with the wires to the top and facing the cylinder. Feed the wires through the upper
hole in the cylinder (J) and install the two screws (K). Tighten the screws to 95 lb-in (10.7 Nm).
2) Pull the stator wires tightly through the cylinder hole, then route them between the ribs as shown
below. Press the wires down (arrows) to the cylinder as far as possible. The wires must not
interfere with the operation of the governor lever.

FLYWHEEL REMOVAL

After removing the flywheel nut, starter cup, and fan, install Flywheel Puller Tool #19203 to remove the
flywheel.
Note that early production flywheels do not have holes for the flywheel puller tool. Instead, a two-jaw puller
(below) can be installed to remove these flywheels. Briggs & Stratton does not currently provide this type of
tool.
J
K
Page 6 of 13