Briggs & Stratton 950 Series Advance Product Service Information page 10

4) If equipped, attach the rocker switch ground wire under the control bracket mounting screw (R6).
Complete the connections to the rocker switch as shown below.
STATIC / DYNAMIC GOVERNOR ADJUSTMENT PROCEDURE
IMPORTANT: The governor lever must be replaced any time the static governing is adjusted!
1) While holding throttle wide open, rotate the governor shaft clockwise until it stops.
2) Tighten the governor lever nut to 40 lb-in (4.5 Nm).
3) Hold the throttle against the idle stop screw on the carburetor. Adjust the screw as required to obtain
1450 RPM or 1750 RPM, depending on application.
4) Adjust the high speed screw on variable-speed engines or bend the spring anchor tab on fixed-speed
engines to obtain the equipment manufacturer's Top No-Load speed (+/- 100 RPM).
Spring Color
Variable Speed
Fixed Speed
Hole Position
Blue
Blue
Blue
Red
White
Green
Yellow
Yellow
Yellow
Black
Black
Black
R6
Top No-Load Speed Range
3 3400 - 3600
4 3700 - 3800
5 3900 - 4200
3
3 3000 - 3200
3 2600 - 2900
3 3200 - 3500
4 3600 - 3900
5 4000 - 4200
3
4 2700 - 2800
5 2900 - 3100
3300
2600
Page 10 of 13