Operation; Hanging On / Removing The Grass Bag; Emptying The Grass Bag; Adjusting The Cut Height - FLORABEST FRM 1800 A1 Translation Of Original Operation Manual

Hang the fabric (18) of the grass
collection bag (4) into the pipe
clip (19).
The textile fabric (18) of the
grass bag (4) must be passed
over the inside of the two
side stabilising bars. The sta-
bilising bars are therefore
visible from the outside. See
image section.
Connect the handle (20) in one
of the two pieces of the collec-
tion box (4).
Do not work with the lawn-
mower without the collision
guard or lawn box. There is
a risk of injury.
The level gauge (21) is located on the side
of the grass catcher (4).
Flap (21) open:
grass catcher (4) empty
Flap (21) closed:
grass catcher (4) full

Operation

Hanging On / Removing the
Grass Bag
1. To hang on the grass bag (4),
E
lift the collision guard (9) and
hang on the grass bag. Fold the
collision guard (9) onto the grass
bag (4). It holds the grass bag in
the correct position.
2. To remove the grass bag (4),
lift the collision guard (9) and
detach the grass bag. Fold the
collision guard (9) back onto the
mower housing.

Emptying the Grass Bag

To empty the grass collection bag,
also use the bottom bag handle (4).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
F
1. Hold the cut height adjusting
lever (5) and guide it past the
indent to the desired cut height
setting.
2. The handle (8) may be used
to help, in order to prevent to
mower rolling away.
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 – 60
mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.

Switching On and Off

1. Connect the equipment to the
G
power supply.
2. Before switching on, ensure that
the equipment is not in contact
with any objects.
3. To switch on, press the release
button (11) on the handle at the
same time as pressing the start
lever. Release the release button
(11).
4. To switch off, release the start
lever (15).
GB
11