Assembly; Assembling The Curved Handle; Operation; Hanging On/Removing The Grass Bag - FLORABEST FRM 1800 B2 Translation Of The Original Instructions

Electrical Safety:
• Ensure that the mains voltage matches
the specifications on the rating plate.
• Connect the equipment only to a sock-
et that has a residual current operated
device (RCD switch) with a trip current
of no more than 30 mA.
• Avoid bodily contact with earthed
parts (e.g. metal fences, metal posts).
• Use only authorised power cables of
H05RN-F, which are no more than
75 m long and suitable for outdoor
use. The power cable wire cross sec-
tion must be at least 2.5 mm
completely unroll cable drums before
use. Check the cable for damage.
• To fix on the power cable, use the
cable suspension intended for the pur-
pose.
• Keep the power cable away from the
cutting tool when working. The cutting
blades may damage the power cable
and result in contact with live parts. Al-
ways run the power cable behind the
operator.
• Do not use the power cable to pull the
plug from the socket. Protect the power
cable from heat, oil and sharp edges.
• Switch off the equipment and discon-
nect the plug from the socket if the
power cable is damaged. If the power
cable is damaged, it must be replaced
by the manufacturer, the customer
services of the same, or a qualified
person, in order to avoid hazards.
• Do not connect a damaged power
cable to the mains. Do not touch a
damaged power cable when it is
connected to the mains. A damaged
power cable may result in contact with
live parts.

Assembly

Assembling the Curved
Handle
B
. Always
2
C

Operation

Hanging On/Removing the
Grass Bag
D
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
1. Remove the two pre-installed
butterfly nuts (2a) from the lawn-
mower housing (7). Insert the
lower bar (3) into the slot on the
lawnmower housing (7).
2. Fix the bottom bar (3) using the
two screws and butterfly nuts
(2a).
3. Fix the curved handle (1) using
the enclosed screws (16) and the
wing nuts (2b) on the lower bar
(3). There are two possible posi-
tions.
4. Clip the cable hooks (
the bar (3) and the handle (1) to
fasten the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.
1. To hang on the grass bag (4),
lift the collision guard (9) and
hang on the grass bag. Fold the
collision guard (9) onto the grass
bag (4). It holds the grass bag in
the correct position.
GB IE
10) into
A
11