Siemens SIMATIC PG 760 PII Manual page 76

Configuring the PG 760 PII
Hard Disk
Timeout
Figure 5-18 "Power" Submenu
CRT
5-22
[Disabled]
[10, 15, 30, 60]
PhoenixBIOS Setup-Utility
Main Advanced Security Power
APM: Enabled
Power Savings: Disabled
Standby Timeout: Off
Suspend Timeout: Off
Hard Disk Timeout: Disabled
CRT Mode: Standby OFF
F1 Help Select Item + / –
ESC Exit Select Menu Enter Select
[Standby Off]
[Suspend Off]
[Always On]
Hard disks are not switched off.
Minutes after which the hard disk drive is
switched off, provided it is not being accessed.
If you attempt to access the hard disk after it
has been switched off, there will be an access
delay while the disk is run up again.
Exit
Item Specific Help
APM (Advanced Power Management)
allows APM aware software to ma-
nage power savings.
Always On
Standby Off
Suspend Off
Change Values F9 Setup Defaults
Sub-Menu F10 Save and Exit
This means that the sync signals to the VGA
interface are switched off in standby mode,
causing the monitor itself to enter standby
mode.
This means that the sync signals to the VGA
interface are switched off in suspend mode.
Monitor always remains in operation.
PG 760 PII Programming Device
C79000-G7076-C766-01