Table of Contents
Advertisement
Option
"Primary
/
A branch is made to the following submenu when you select this type of
Secondary"
menu option:
Figure 5-3
The parameters which you can select here are usually saved on the respective
IDE drive, and are read from the drive and entered into the form when you
select the option "Autodetect Hard Disk."
Option "Type "
If you select the option "Type" for a drive which does not exist, an abort is
executed after approximately one minute as a result of a timeout and the
existing entries remain unchanged. It is therefore only meaningful to carry
out an autodetect for interfaces to which drives are connected.
Under certain circumstances it may be necessary to deviate from the
proposed hard disk parameters. In this case, select the corresponding menu
option and then the desired value using the [+] and [–] keys. Enter "none" in
the option "Type" if no drive is connected, or a number from 1 to 39 if a
predefined type of hard disk is to be used.
Select "User" if you wish to define your own type of hard disk; you must
then additionally enter the hard disk-specific parameters in the options
"Cylinders," "Heads," "Sectors/Track," "Write Precomp."
PG 760 PII Programming Device
C79000-G7076-C766-01
PhoenixBIOS Setup Utility
Main
Advanced
Security
Primary Master [3249MB]
Type:
[Auto]
Cylinders:
[ 10850]
Heads:
[
Sectors:
[
Maximum Capacity:
5250MB
[16 Sectors]
Multi-Sector Transfers:
[Enabled]
LBA Mode Control:
32 Bit I/O:
[Enabled]
Transfer Mode:
[FPIO 4 / DMA 2]
Ultra DMA Mode:
F1
Help
Select Item
+ / –
ESC
Exit
Select Menu
Enter Select
Example: "Primary Master"
Configuring the PG 760 PII
Power
Exit
Item Specific Help
[AUTO] (recommended)
Autotypes installed
IDE–devices
15]
63]
[USER]
Enter parameters of
IDE-devices installed
at this connection
[1-39]
Select predetermined type of
hard-disk drive
Change Values
F9
Setup Defaults
Sub-Menu
F10
Previous Values
5-7
Advertisement
Table of Contents
