Table of Contents
Advertisement
Installing the
Plug the DIMM cards in as follows:
DIMM Cards
1. Turn off the unit and unplug the power cable.
2. Open the unit as described in Section 4.1.
3. Remove all inserted ISA modules.
4. Plug the card in vertically, making sure the cut-out on the connector end
5. Apply light pressure to the DIMM card until it clicks into place. You can
6. Close the unit (see Section 4.7).
Caution
!
Risk of damage!
The cards must sit firmly in their slots, otherwise they might be damaged.
Plug the cards into their slots vertically before locking them in position.
Caution
!
Risk of short-circuit!
Incorrect insertion of the DIMM card may result in destruction of the card
and the mother board. Ensure that the contacts of the DIMM card and the
receptacle are flush.
Installation
The system recognizes the new memory configuration automatically. When
you power up the unit, the base and extended memory information appears
automatically on the screen.
PG 760 PII Programming Device
C79000-G7076-C766-01
of the DIMM card engages properly.
easily remove the card again by releasing the clips.
PG 760 PII Expansions
4-11
Advertisement
Table of Contents
