Siemens SIMATIC PG 760 PII Manual page 65

Submenu
In this form you can determine whether the device should be booted from the
Hard Drive Boot IDE primary master first. The hard disk is connected to this interface at the
Device
factory.
Figure 5-6
Submenu
Diskette Boot
Device
Figure 5-7
PG 760 PII Programming Device
C79000-G7076-C766-01
PhoenixBIOS Setup Utility
Main Advanced Security
Hard Drive Boot Device
1. [Primary Master]
2. [Alternate Device]
F1 Help Select Item + / –
ESC Exit Select Menu Enter Select
"Hard Drive Boot Device" Submenu
PhoenixBIOS Setup Utility
Main Advanced Security
Diskette Boot Device
1. [Floppy Drive]
F1 Help Select Item + / –
ESC Exit Select Menu Enter Select
"Diskette Boot Device" Submenu
Configuring the PG 760 PII
Power Exit
Item Specific Help
Move the prefered boot device
to top of list.
The order of the list will be the
order of boot sequence.
Use < > or < > to select a de-
vice, then press <+> to move it
up the list, or <–> to move it
down the list.
Press <Esc> to exit the menu.
Change Values F9 Setup Defaults
Sub-Menu F10 Save and Exit
Power Exit
Item Specific Help
Move the prefered boot device
to top of list.
The order of the list will be the
order of boot sequence.
Use < > or < > to select a de-
vice, then press <+> to move it
up the list, or <–> to move it
down the list.
Press <Esc> to exit the menu.
Change Values F9 Setup Defaults
Sub-Menu F10 Save and Exit
5-11