Table of Contents
Advertisement
Harddisk Delay
Memory Gap at
15 MByte
Enable memory
ECC
Submenu
COM/LPT
Configuration
Figure 5-11 "COM / LPT Configuration" Submenu
If you set an interface to Disabled, the resources occupied by it are released.
Mode:
Printer port
Internal LPT1
PG 760 PII Programming Device
C79000-G7076-C766-01
[Disabled]
3 to 30
[Disabled]
[Enabled]
[Disable]
[Enable]
PhoenixBIOS Setup Utility
Main
Advanced
Security
COM / LPT Configuration
Internal COM 1:
[Enabled]
Base I/O address:
[3F8]
Interrupt:
[IRQ 4]
Internal COM2:
[Enabled]
Base I/O address:
[2F8]
Interrupt:
[IRQ 3]
Internal LPT1:
[Enabled]
[Output only]
Mode:
Base I/O address:
[378]
Interrupt:
[IRQ 7]
F1
Help
Select Item
+ / –
ESC
Exit
Select Menu
Enter Select
You can use this setting to select the operating mode of the printer
interface. You must adapt this setting to match the data terminal
device which you have connected. You can find the setting in the
corresponding device documentation.
Configuring the PG 760 PII
No additional startup time for hard disk
Additional startup time for the hard disk
can be selected
The area from 15 to 16 Mbytes is not available
forISA RAM
The area from 15 to 16 Mbytes is enabled for
the ISA memory.
No "Error checking and correction"
"Error checking and correction" are active
Only meaningful in connection with DIMM
cards with ECC
Power
Exit
Item Specific Help
Configure internal COM
port using options:
[Disabled]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
[OS Controlled]
Displayed when
controlled by OS
Change Values
F9
Sub-Menu
F10
Setup Defaults
Save and Exit
5-15
Advertisement
Table of Contents
