Texas Instruments TravelMate 3000 User Manual page 146

Troubleshooting
E-2 Troubleshooting
Computer comes on
when turned on but
turns off before boot-
ing.
Computer Power in-
dicator light on, Low
Batt Indicator blink-
ing, screen blank, and
computer will not run.
The built-in LCD
screen is blank.
Internal battery pack still too
warm-Wait about 3 more
minutes and try again.
Automatic discharge cycle
not complete-Leave Power
switch in on position until
all indicator lights go out;
then plug in AC Adapter
after automatic battery dis-
charge cycle completes and
run computer on ac power.
If Power indicator is orange-
press the Fn-F4 (Stndby)
keys to resume operation.
Blinking Low Batt indicator
signals that computer will
shut off in about 1 minute.
None o the above-Contact
your Texas Instruments
reseller.
Screen contrast/brightness
controls-Adjust the contrast
and brightness controls on
the right side of the LCD
screen.
Computer set up or external
monitor-Turn computer off,
wait 5 seconds, turn com-
puter on; or use ALTVID
command to switch back to
the LCD (see Chapter 6 of
this manual).