Siemens SINUMERIK Commissioning Manual page 259

6.5 Grinding tools and tool-specific grinding data
Overview
The HMI Advanced tool management is modified so that the "tool-specific grinding data" of
grinding tools is displayed and can be edited.
This data is exchanged with the NC via the OPI block TG; it largely corresponds to the NC
variables $TC_TPG1 to $TC_TPG9.
For more information on softkey extension in the tool details main screen, tool details cutting
edge data screen and tool detail monitoring data screen, see:
References: Operating Manual HMI-Advanced
Setting parameters for the default values
The parameters for the default values for the tool-specific grinding data when creating tools
are set in the "paramtm.ini file, section [DEFAULT_ SETTINGS].
Description
[DEFAULT_SETTINGS]
; !!! Default setting of grinding-specific tool data at creation:
; !!! If the machine is operating with inch/mm
; !!! ($MN_CONVERT_SCALING_SYSTEM=1) conversion,
; !!! the length unit must be specified !!!
; The following default values (TOOLGRIND..., if affected
; by the length unit) are specified on the basis
; of this length unit:
; 0 = mm (default)
; 1 = inch
TOOLGRIND_Default_Length_Unit=0
; Spindle number (as $TC_TPG1)
TOOLGRINDspinNoDress=1
; Chain rule (as $TC_TPG2)
TOOLGRINDconnectPar=1050629
;1050629 binary: 0000 0000 0001 0000 0000 1000 0000 0101
;Bit0 =1 = Type
;Bit2 =1 = Geo-L1
;Bit11 =1 = Wear-L1
;Bit20 =1 = Base-L1
;Minimum wheel radius (as $TC_TPG3)
TOOLGRINDminToolRadius=0
;Minimum wheel width (as $TC_TPG4)
TOOLGRINDminToolWide=0
;Current width of grinding wheel (as $TC_TPG5)
TOOLGRINDactToolWide=0
; Maximum grinding wheel speed (as $TC_TPG6)
TOOLGRINDmaxRotSpeed=0
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
6.5 Grinding tools and tool-specific grinding data
Tool management
253