Using An Optical Drive - eMachines A26EV17F Manual

Using an Optical Drive

To insert a CD/DVD into the optical drive, first turn on your system. Then press the load/eject button
to open the disc tray. When the disc tray pops out, the busy indicator light will flash. Put the
CD/DVD in the tray with the label side up. Press the load/eject button again or gently push the disc
tray to close it.
CD/DVD
When you want to remove the CD/DVD, make sure the busy indicator is off; then press the
load/eject button. When the tray pops out, remove the CD/DVD and then press the button again to
close the tray.
NOTES
When your system is turned off, you may need to open the tray. At this time, insert a fine rod such as
an opened paper clip into the emergency eject hole as far as it will go. When the tray is slightly open,
carefully pull it out.
Your computer references the upper optical drive as D: and the lower optical drive (optional) as E:
unless you have more than one hard disk drive or partition.
The high speed DVD-ROM drive (above 6x) may take few seconds to stop the running of the spindle
motor when you press the eject button, immediately after using CD or DVD, to open the tray. Wait
about 5 to 10 seconds after pressing the eject button to give the DVD sufficient time to stop the
running of the spindle motor and eject the tray.
3-4
Using Your Computer
All manuals and user guides at all-guides.com