Hyundai HST4020 Instructions Manual
Hyundai HST4020 Instructions Manual

Hyundai HST4020 Instructions Manual

Scarifier petrol 212 cm3
Hide thumbs Also See for HST4020:

Advertisement

SCARIFIER PETROL 212 cm³
HST4020

Advertisement

Table of Contents
loading

Summary of Contents for Hyundai HST4020

  • Page 1 SCARIFIER PETROL 212 cm³ HST4020...
  • Page 2: Table Of Contents

    Contents 1. Know your petrol scarifiers ........... 1 2. Symbols marked on the product ..........1 3. General safety information ..........2 3.1 Preparations ................ 2 3.2 Handing ................2 3.3 Maintenance and storage............. 3 Layout and items supplied ........... 7 4.1 Layout ................
  • Page 3: Know Your Petrol Scarifiers

    Know your petrol scarifiers Read this manual carefully, observing the recommended safety instructions before, during and after using your lawn mower. Following these simple instructions will also maintain you lawn mower in good working order. Familiarize yourself with the controls on your mower before attempting to operate it, but above all, be sure you know how to stop your mower in an emergency.
  • Page 4: General Safety Information

    General safety information Read these instructions carefully before use and keep them for later reference. Note Read the operating instructions carefully. Be familiar with the controls and the proper use of the machine. Local regulations can restrict the age of the operator. 3.1 Preparations a) Never allow children or other persons who are not familiar with the operating instructions to use the equipment.
  • Page 5: Maintenance And Storage

    i) Be particularly careful when you turn the equipment around or pull it toward yourself. j) Stop the tools if the equipment has to be tipped to one side for transport purposes, stop the tools if you cross any surfaces other than grass and whilst transporting the equipment from and to the area you wish to use it on.
  • Page 6 0083...
  • Page 7 0083...
  • Page 8 min. max. 0083...
  • Page 9: Layout And Items Supplied

    Layout and items supplied 4.1 Layout (Fig. 1/2) 1. Engine start/stop lever – engine brake 7. Throttle lever 2. Top push bar 8. 2 fastening nuts for top push bar 3. Bottom push bar 9. 4 fastening screws for bottom push bar 4.
  • Page 10: Technical Date

    Please note that our equipment has not been de‐ signed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Technical data Engine type 1 cylinder, Engine oil(L)
  • Page 11: Operation

    Operation Important! The engine does not come with oil in it. Therefore, be sure to add oil before starting the engine. The oil level in the engine must be checked each time before carrying out any work. Important! When the engine brake lever is re‐ leased it must return to its initial position and the engine must stop. If this is not the case, do not use the equipment again.
  • Page 12: Cleaning, Maintenance, Storage, Transport And Ordering Of

    Important! For transport move the lever for set‐ ting the depth to the highest position. Tips for proper working It is recommended that you overlap scarifying paths a little. Try to scarify in straight lines for a nice, clean look. Insodoing, the aeration swaths should always overlap each other by a few centi‐ meters in order to avoid bare strips.
  • Page 13: Preparing The Equipment For Storage

    Never run the engine with no or too little oil. This can cause serious damage to the engine. Changing the oil Change the engine oil every year before the start of the season (in addition to the informa‐ tion in the petrol service manual) when the engine is warm. Use only recommended engine oil.
  • Page 14: Preparing The Device For Transport

    9.4 Preparing the device for transport Drain the petrol tank using a petrol extraction pump. Always let the engine run until it has used up the remainder of petrol in the tank. Empty the engine oil from the warm engine. Remove the spark plug boot from the spark plug.
  • Page 15: Service Information

    Service information We have competent service partners in all countries named on the guarantee certificate whose contact details can also be found on the guarantee certificate. These partners will help you with all service re‐ quests such as repairs, spare and wearing part orders or the purchase of consumables. Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required for use as consumables.
  • Page 16: Ec-Declaration Of Conformity

    EC DECLARATION OF CONFORMITY For the following machinery: Product name: Petrol Scarifier Commercial name: N/A Function: N/A Type: Gasoline Model No.: HST4020 is herewith confirmed to fulfill all the relevant provisions of Machinery Directive (2006/42/EC) and the following harmonized standard have been complied with EN 13684:2004+A3...
  • Page 17 0083...

Table of Contents