Notes For The Installer; Installing And Securing The Machine; Transit Fittings - Miele PW 6163 Operating Instructions Manual

Notes for the installer

This machine must be installed by an
authorised technician only.

Installing and securing the machine

See also the installation diagram
supplied.
To avoid the risk of frost damage do not
install this machine in a room where there is
a risk of frost occuring.
The machine must be level and secure after
installation.
The machine can be secured to the floor
using the existing drill holes in the base
frame of the machine.
^ To access them both side panels have to
be dismantled.
1
^ The frequency converter casing has to be
dismanted by undoing 3 screws
(Illustration 1) and then hung to the side
(Illustration 2).
^ With steam heated machines the steam
connection bracket also has to be
dismantled.
40
2
^ The machine can then be screwed to the
floor through the four holes now visible in
the machine's base frame.
Do not install the machine on carpeted
flooring as the carpet pile can hinder the
free flow of air into the ventilation gaps at the
bottom of the machine.

Transit fittings

The transit fittings, two on the clean side and
two on the unclean side, should not be
removed until the machine is set up in its
final location and is ready for
commissioning.
4 transit fittings
Store the transit fittings in a safe place for
future use. They will need to be refitted
should the machine every need to be
moved to another location.
Use a pallet lifter to move the machine
around the room.
Plinth facings are supplied separately with
the machine and must be fitted after it has
been set up. The earth lead (green-yellow)
must then be connected.