Notes For The Installer - Miele WS 5073 SLUICE Operating Instructions Manual

Notes for the installer

Installation
A concrete floor is the most suitable installa-
tion surface.
Please note:
The machine must be level and securely
positioned.
Do not install the machine on a 'soft' base
such as floorboards as this could result in
more vibration during the spin cycles.
If the machine is installed on a raised
plinth it should be secured using the butt
straps supplied with the machine.
If there is not already a concrete plinth on-
site, the Miele Spare Parts department offer a
steel plinth. It must be ensured that the steel
plinth is secured to the floor, (see the en-
closed installation plan).
To avoid the possibility of frost damage on no
account install the machine in a room which is
exposed to frost.
Do not install the machine on carpeted floor-
ing if the carpet pile blocks the ventilation gap
at the base of the machine.
Transit fittings
When the machine has been installed in its
final position, only then remove the red transit
fittings marked "A", "B". and "C".
The machine must not be moved without
the transit fittings in place.
The transit fittings should be stored in a safe
place for future use. They must be re-fitted if
the machine is moved again.
M.-Nr. 05068971/03
Front transit fitting
The front panel must be taken off, (2 internal
torx T20 screws at the bottom) to remove the
front transit fitting (3 SW-13 screws) .
Rear transit fitting
"B" (1piece)
The rear panel must be taken off, (just loosen
15 internal torx T20 screws at the bottom) to
remove the rear transit fitting (3 SW13
screws each) .
The machine must not be moved without
all the outer panels in place.
26
"A" (1piece)
"C" (1piece)