Table of Contents
Advertisement
Installation
This machine is for use only with articles
which have not been treated with dan-
gerous or inflammable substances.
To avoid the possibility of frost damage on no
account install the machine in a room which is
exposed to frost.
Transit fittings
The red-marked fixing brackets, 2 at the side
front and 2 at the side rear for the transport
verschlag are each secured with a hex screw
(SW 17) and must be removed. The service
panels are located on the machine.
The red marked transit fittings, 2 at the front
and
M.-Nr. 05730940
2 at the rear are each secured with 3 hex
screws (SW 17) and must only be removed
once the machine has been installed in its
final position. Ensure they are removed be-
fore commissioning.
To remove them detach the lower sides from
the machine.
Transit fittings should be stored in a safe
place for future use. They must be refitted
if the machine is moved again.
It is essential that the machine is installed
level, and is secured (see Installation diagram
supplied).
Do not install the machine on carpeted floor-
ing if the carpet pile blocks the ventilation gap
at the base of the machine.
After installing and connecting the machine
to the services ensure that all outer panels
have been put back in place.
32
Hide quick links:
Advertisement
Table of Contents
