Table of Contents
Advertisement
Chapter
Using the show controllers e1 Command
Use the show controllers e1 command to identify the E1 cable type (balanced or unbalanced) attached to a
PA-2CE1 that is configured for channelized E1.
Cisco 7200 Series Routers
Following is an example of the show controllers e1 command that shows a channelized E1 interface port
(1/0) with an unbalanced cable attached:
Router# show controllers e1 1/0
E1 1/0 is up.
Applique type is Channelized E1 - unbalanced
No far end block errors detected
No alarms detected.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (710 seconds elapsed):
Data in Interval 1:
[display text omitted]
Following is an example of the show controllers e1 command that shows an E1 interface port (1/0) that
is configured for ISDN PRI:
Router# show controllers e1 1/0
E1 1/0 is up.
No alarms detected.
No far end block errors detected
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (710 seconds elapsed):
Data in Interval 1:
[display text omitted]
OL-3519-01
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
Checking the Configuration
4-21
Advertisement
Table of Contents
