Cisco PA-2CE1 Series Installation And Configuration Manual page 35

Chapter
insulated jumper is not present on jumper locations J4 and J10. Table 3-1 lists the 2CE1 jumper locations
and their jumper settings. Figure 3-4 and Figure 3-5 show balanced 120-ohm and unbalanced 75-ohm
2CE1 jumper configurations, respectively.
In balanced 120-ohm and unbalanced 75-ohm configurations, an insulated jumper covers
Note
the left two pins of jumper locations J7 and J13; it is not present on jumper location J15.
(See Table 3-1.)
Table 3-1
Balanced 120-Ohm
Configuration
Jumper
Location
J2
J3
J5
J7
J8
J9
J11
J12
J13
J14
J4
J10
J15
OL-3519-01
2CE1 Jumper Locations and Settings
Unbalanced 75-Ohm
Configuration
Jumper Setting Jumper
Location
Right two pins J2
Right two pins J3
Right two pins J5
Left two pins J7
Right two pins J8
Right two pins J9
Right two pins J11
Right two pins J12
Left two pins J13
Right two pins J14
Present J4
Present J10
Not present J15
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
Jumper Setting
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Left two pins
Not present
Not present
Not Present
Setting the PA-2CE1 Jumpers
3-9