Cisco PA-2CE1 Series Installation And Configuration Manual page 40

Configuring the PA-2CE1 Interfaces
Step 3 Shut down the interface by entering the interface serial subcommand (followed by the interface address
of the interface), and then enter the shutdown command. Table 4-2 shows the command syntax.
When you have finished, press Ctrl-Z—hold down the Control key while you press Z—or enter end or
exit to exit configuration mode and return to the EXEC command interpreter.
Table 4-2 Syntax of the shutdown Command
Platform
Cisco 7200 series routers
VIP2 in Cisco 7000 series and
Cisco 7500 series routers
Write the new configuration to NVRAM as follows:
Step 4
Router# copy running-config startup-config
[OK]
Router#
The system displays an OK message when the configuration has been stored in NVRAM.
Verify that new interfaces are now in the correct state (shut down) using the
Step 5
show interfaces command (followed by the interface type and interface address of the interface) to
display the specific interface. Table 4-3 provides examples.
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
4-4
Command
interface, followed by the type
(serial) and slot/port
(port-adapter-slot-number/
interface-port-number)
interface, followed by the type
(serial) and slot/port adapter/port
(interface-processor-slot-number
port-adapter-slot-number/
interface-port-number)
Example
The example is for interface 0 in port adapter slot 1
being shut down.
Router(config-if)# interface serial 1/0
Router(config-if)# shutdown
Ctrl-Z
Router#
The example is for interface 0 on a port adapter in
port adapter slot 0 of a VIP installed
in interface processor slot 1.
Router(config-if)# interface serial 1/0/0
Router(config-if)# shutdown
Ctrl-Z
Router#
Chapter
OL-3519-01