Cisco PA-2CE1 Series Installation And Configuration Manual page 56

Checking the Configuration
The following example of the show interfaces serial slot/port adapter/port:pri-group command shows
all of the information specific to the same interface port (interface port 1 in chassis slot 3, port adapter
slot 1) when the port is configured for ISDN PRI:
Router# show interfaces serial 3/1/1:15
Serial3/1/1:15 is up, line protocol is up (spoofing)
Hardware is cxBus E1
Internet address is 10.1.15.1
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions alarm present
Timeslot(s) Used:1-31, Transmitter delay is 0 flags, transmit queue length 0
In the above example, the term "spoofing" indicates that the interface is configured for
Note
ISDN PRI. The term "spoofing" is indicated only on timeslot 16 (the D channel), which is
recognized by the system as timeslot 15.
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
4-20
Chapter
OL-3519-01