Cisco PA-2CE1 Series Installation And Configuration Manual page 55

Channelized e1 port adapter
Table of Contents

Advertisement

Chapter
The following example of the show interfaces serial port adapter slot number/interface port
number:pri-group command shows all of the information specific to the same interface (interface port 1
in port adapter slot 1) when the interface is configured for ISDN PRI:
Router# show interfaces serial 1/1:15
Serial1/1:15 is up, line protocol is up (spoofing)
Hardware is MPA-E1
Internet address is 10.1.15.1
MTU 1500 bytes, BW 1984 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set
Last input 00:00:42, output 00:00:56, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/64/0 (size/threshold/drops)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Timeslot(s) Used:1-31, subrate: 64Kb/s, transmit delay is 0 flags
VIP2 in Cisco 7000 Series and Cisco 7500 Series Routers
The following example of the show interfaces serial slot/port adapter/port:channel-group command
shows all of the information specific to the second 2CE1 interface port (interface port 1) in chassis slot
3, port adapter slot 1, channel group 2:
Router# show interface serial 3/1/1:2
Serial3/1/1:2 is up, line protocol is up
Hardware is cxBus E1
Internet address is 10.1.15.1
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Timeslot(s) Used:1-31, Transmitter delay is 0 flags, transmit queue length 0
OL-3519-01
Conversations
0/1 (active/max active)
Reserved Conversations 0/0 (allocated/max allocated)
149 packets input, 40207 bytes, 0 no buffer
Received 298 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
128 packets output, 44416 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
20 carrier transitions no alarm present
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions alarm present
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
Checking the Configuration
4-19

Advertisement

Table of Contents
loading

Table of Contents