Assembly; Packing List; Symbols In This Manual - Homelite HLT33MTB Original Instructions Manual

Original instructions
Waiting time: 10 seconds
PRIME - press the primer bulb 10 times
slowly
Pull the starter grip
Squeeze throttle trigger to start / run.
Set the ignition switch to the "I" (ON)
position.
Use unleaded petrol intended for motor
vehicle use with an octane rating of
91([R+M]/2) or higher.
Starting a cold engine by hand
Starting a warm engine by hand
Use 2-stroke lubricant for air cooled
engines.
Mix the fuel mix thoroughly and also each
time before refueling.
TRI-ARC blade is appropriate for the
product and is suited for cutting pulpy
weeds and vines.
Beware of blade thrust
Rotational direction and maximum speed
8 470
of the shaft for the cutting attachment.
Regulatory Compliance Mark (RCM).
This product meets applicable regulatory
requirements.
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
DANGER
Indicates an imminently hazardous situation, which, if
not avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
8
| English
CAUTION
Without safety alert symbol
Indicates a situation that may result in property damage.

SYMBOLS IN THIS MANUAL

Note
Warning

ASSEMBLY

UNPACKING
The product requires assembly.
■ Carefully remove the product and any accessories from
the box. Make sure that all items listed are included.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.

PACKING LIST

■ Power head & upper boom x 1
■ Brushcutter attachment X 1
■ Hedge trimmer attachment X 1
■ Pole pruner attachment X 1
■ Drive tube assembly X 1
■ Harness X 1
■ Nylon locking nut x 3
■ Manual x1
■ Pruner scabbard x 1
■ Cutting attachment guard x 1
■ Front handle assembly x 1
■ String head x 1
■ Combination wrench x 1
■ Wrench (13 mm) x 1
■ Wrench (10 mm) x 1
■ Allen wrench (5 mm) x 1
■ Allen wrench (4 mm) x 1
■ Chain bar x 1
■ Chain x 1