Install The Drivers - Technicolor TG122N Setup And User Manual

2 Install the Drivers

Introduction
Before your computer can recognize and use the Wireless USB Adaptor you first need to install the necessary drivers.
Do not connect your wireless device to your computer until you are instructed to do so.
Procedure
Proceed as follows:
1 Insert the Setup CD in your computer's CD-ROM or DVD-ROM drive.
Result: The CD should autostart. If not, click Run on the Start menu and enter the following path: D:\Setup.exe where
D stands for the drive letter of your CD-ROM or DVD-ROM drive.
2 Carefully follow all the instructions.
If your security software prompts you that changes have been made to your system, allow these changes.
3 Continue with "3 Associate your Wireless USB Adaptor to your Access Point" on page
E-DOC-CTC-20100623-0002 v2.0
2 INSTALL THE DRIVERS
7.
5