Table of Contents
Advertisement
EN
2 / USING YOUR APPLIANCE
PREHEAT
•
Preheating quickly heats your preparation
before cooking continues at a selected power
level.
Procedure :
- After choosing power level 12, switch to pre-
heat mode by pressing the "
'PC' will appear on the display.
- Now select your power level for cooking after
preheating.
- You will hear a beep.
- When 'PC' and the selected power level are
displayed alternately, preheating has begun.
- After preheating is complete, the display will
only show the selected power setting. You are
now in normal cooking mode.
WARNING
- If you do not choose a power level when
'PC' is displayed, the cooking zone shuts off.
- Your hob automatically calculates the pre-
heat time according to the power level you
select.
- Preheating is not available if you choose a
power level under 6.
- Pressing any power level buttons stops pre-
heating. You will switch to normal cooking
mode.
Tip
When several pots are on the hob, try
using cooking zones on opposite sides. If
they are on the same side, using power
boost for one zone will automatically
reduce power for the other, as shown on
the display. This automatic power reduc-
tion also occurs when preheating.
•
+"
button.
•
14
SETTING TIMERS
Each cooking zone has its own timer. It can be
used when the zone is on. To start or set it,
push the corresponding "
For quicker setting of long cooking times, skip
to 99 minutes by immediately pressing "
When cooking is finished, '0' is displayed and
a beep is heard. To clear the display, press
any button for the zone in use.
The display is otherwise automatically cleared
in a few moments.
Elapsed time
You can see how long it has been since the
last power level adjustment for a particular
zone by holding down the
elapsed time blinks in the timer display of the
selected zone.
If you would like to stop cooking before a cer-
tain time, first press the
within 5 seconds, use the timer "
define the remaining cooking time.
It will be displayed for 3 seconds before the
countdown is shown. You will hear a beep if
the time has been properly set. This function
can be used with or without the timer.
N.B.: If a time is displayed on the timer, it can
only be changed after 5 seconds
+"
-"
or "
buttons.
-"
.
.button. The
button. Next,
+"
button to
Advertisement
Table of Contents
