Pan Detection; Residual Heat Indication; Timer - Smeg SIHP3+WG4 Directions For Use Manual

 Start-up/ switch off a heating zone :
Action
Increase power
Decrease power
Stop

Pan detection

The pan detection ensures a perfect safety.
The induction doesn't work :
 If there is no pan on the heating zone or if this pan is not adapted to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a pan is put on the heating zone.
 If the pan is removed from the heating zone the operation is stopped. The display shows
[ U ]. The symbol [ U ] disappears when the pan is put back to the heating zone. The
cooking continues with the power level setted before.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disapears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put
any heat sensitive object on them . There are risks of burn and fire.

Timer

The timer is able to be used simultaneous with all 4 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.
Setting and modification of the cooking time
Action
To select a heating zone
To select the power level
To select « Timer »
Decrease the time
Increase the time
After a few seconds the control light stops with blinking.
The time is confirmed and the cooking starts until the time reaches [ 00 ].
To stop the cooking time
Action
To select a heating zone
To select « Timer »
To stop the « Timer »
If several timers are activated repeat the process.
Automatic stop at the end of the cooking time:
As soon as the selected cooking time is finished the timer displays blinking [00] and a sound rings.
To stop the sound and the blinking it is enough to press the key [
Control panel
touch key [ + ]
touch key [ - ]
touch simultaneous [ + ] and [ - ]
Control panel
Press on key [ + ]
Press on key [ + ] or [ - ]
Press on key [
Press on key [ - ]
Press on key [
Control panel
Press on key [ + ]
Press on key [
Press on key [ - ] and [
Display
The zone control light is on
[ 1 ] .... [ 9 ] [ P ]
] The time displays [ 00 ]
[60] wents to 59,58,57,......
] The time increases...
Display
The zone control light is on
] The remaining time
] Displays [00] then stops
8
Display
[ 1 ] to [ 9 ]
[ 9 ] to [ 1 ]
[ 0 ] or [ H ]
].