Table of Contents
Advertisement
• If the chest pulse sensor still does not function prop-
erly, test the chest pulse sensor in the following way:
Hold the chest
pulse sensor
and place your
thumbs over the
electrode areas
as shown.
Next, hold the chest pulse sensor near the console.
While holding one thumb stationary, begin tapping
the other thumb against the electrode area at a rate
of about one tap per second. Check the heart rate
reading on the console.
All manuals and user guides at all-guides.com
Electrode Areas
• If the chest pulse sensor does not function properly
after you have followed all of the above instructions,
replace the battery in the following way:
Locate the battery
cover on the back of
the sensor unit. Insert
a coin into the slot in
the cover, turn the
cover counterclock-
wise, and remove the
cover.
Remove the old bat-
tery and insert a new
CR 2032 battery.
Make sure that the
battery is turned so
the writing is on top.
Reattach the battery
cover and turn it
clockwise to close it.
13
CR 2032
Battery
Advertisement
Table of Contents
