Fueling - Stihl HL 90 Instruction Manual

Fueling

Preparations
N Before fueling, clean the filler cap
and the area around it so that dirt
cannot fall into the tank.
N Always position the machine so that
the filler cap is facing upwards.
A number of different filler caps are
installed as standard at the factory.
Cliplock filler cap (bayonet-type)
HL 90 K
Threaded filler cap
Opening the cliplock filler cap
N Swing the clip into an upright
position
N Turn the cap counterclockwise
(approx. 1/4 turn)
N Remove the filler cap
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
Closing the cliplock filler cap
N Position the cap with the clip in an
upright position; the markings must
line up
N Turn cap clockwise as far as it will
go (approx. 1/4 turn)
N Fold the cliplock down so that it is
flush with the surface
If the cliplock is not flush with the surface
and the lug on the clip does not engage
entirely in the recess (arrow), the cap is
not properly closed and the steps
described above must be repeated.
English
11