NordicTrack Elite 700 NTL79020.1 User Manual page 26

HOW TO CONNECT YOUR HEART RATE MONITOR
TO THE CONSOLE
The console is compatible with all Bluetooth Smart
heart rate monitors.
To connect your Bluetooth Smart heart rate monitor to
the console, press the iFit Sync button on the console.
The LED on the console will flash twice once the con-
nection is successful. Note: This may take up to 15
seconds.
Note: If there is more than one compatible heart rate
monitor near the console, the console will connect to
the heart rate monitor with the strongest signal.
To disconnect your heart rate monitor from the console,
press and hold the iFit Sync button on the console for
5 seconds.
Note: All Bluetooth connections between the console
and other devices (including any smart devices, heart
rate monitors, and so forth) will be disconnected.
HOW TO USE THE SOUND SYSTEM
To play music or audio books through the console
sound system while you exercise, plug a 3.5 mm male
to 3.5 mm male audio cable (not included) into the jack
on the console and into a jack on your personal audio
player; make sure that the audio cable is fully
plugged in. Note: To purchase an audio cable, see
your local electronics store.
Next, press the play button on your
personal audio player. Adjust the vol-
ume level using the volume increase
and decrease buttons on the console
or the volume control on your personal
audio player.
ETNT79020
THE SETTINGS MODE
The console features an information mode that keeps
track of treadmill information and allows you to person-
alize console settings.
1. Select the information mode.
To select the settings mode, press the Settings
button. When the settings mode is selected, the
display will show the total number of hours that
the treadmill has been used and the total number
of miles (or kilometers) that the walking belt has
moved.
2. Select the optional screens.
While the information mode is selected, the matrix
will display several optional screens. Press the
increase button next to the Enter button to select
each of the following screens:
UNITS—To change the unit of measurement, press
the Enter button. To view distance in miles, select
ENGLISH. To view distance in kilometers, select
METRIC.
INCLINE CALIBRATION—To calibrate the incline
system of the treadmill, press the Incline increase
or decrease buttons. The treadmill will automati-
cally rise to the maximum incline level and then
return to the minimum level.
CONTRAST LVL—Press the Incline increase and
decrease buttons to adjust the contrast level of the
display.
DEMO—The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. While the demo mode is turned
on, the console will function normally when you
plug in the power cord, press the power switch
into the reset position, and insert the key into the
console. However, when you remove the key, the
displays will remain lit, although the buttons will not
function. If the demo mode is turned on, the word
ON will appear in the display. To turn on or turn off
the demo mode, press the Enter button.
3. Exit the settings mode.
To exit the settings mode, press the Settings
button.
26