Table of Contents
Advertisement
20. Press the two tabs (not shown) on the Tablet
Holder (31) into the slots (W) in the console
assembly (L).
Then, attach the Tablet Holder (31) with four
M4 x 16mm Machine Screws (32). Note: Start
the two top Screws first, and then start the
two bottom Screws. Be careful not to over-
tighten the Screws.
IMPORTANT: The Tablet Holder (31) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see page 31). Note: Extra hardware may be included.
20
Start First
32
18
31
32
L
W
Hide quick links:
Advertisement
Table of Contents
