Table of Contents
Advertisement
10. With the help of a second person, hold the
console assembly (L) near the console base
assembly (G).
Connect the wires (M) from the console base
assembly (G) to the wires (N) from the console
assembly (L). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
Next, locate the console wire (O) in the con-
sole assembly (L). Connect the console wire
to the Upright Wire (81).
(M, N) into the hole in the Console Base (64).
Insert the wires (O, 81) into the console assem-
bly (L), and position the wires on the decal.
11. Set the console assembly (L) on the brackets on
the console base assembly (G). Do not pinch
any wires. Make sure that the wires (O, 81) are
inserted into the console assembly.
Attach the console assembly (L) with two
5/16" x 1 3/4" Screws (12) and two 5/16" Star
Washers (11); start both Screws, and then
tighten them. Note: Only one side is shown.
Then, insert the wires
10
N
M
64
11
13
L
O
81
12
11
L
G
O, 81
G
Hide quick links:
Advertisement
Table of Contents
