Of The Cover Brackets (18) Into The Slot (F) In The - NordicTrack Elite 700 NTL79020.1 User Manual

6. See the left drawing. Insert the tab (E) on one

of the Cover Brackets (18) into the slot (F) in the

Left Upright (89), and attach the Cover Bracket
with two #8 x 1/2" Screws (1).
See the right drawing. Attach the other
Cover Bracket (18) to the Right Upright (90) as
described above. Note: On the Right Upright,
the slot (F) is below the two small holes. The
Cover Bracket will need to be rotated 180º
compared to the Cover Bracket on the left
side.
Position the Upright Wire (81) on the left side of
the Right Upright (90) as shown.
7. With the help of a second person, set the
console base assembly (G) on the Right Upright
(90) and the Left Upright (not shown). See the
inset drawing. Position the Upright Wire (81) so
that it is on the inside of the Upright as shown.
Do not pinch the Upright Wire.
Partially tighten a 5/16" x 3/4" Screw (8) into the
center hole (H) on each side of the console
base assembly (G) and into the top of the Right
Upright (90) and the Left Upright (not shown);
do not fully tighten the Screws. Note: The
Screws are used only to hold the console
base assembly in place during assembly.
6
89
F
E
18
1
7
81
90
11
81
18
F
E
1
81
8
H
90
H
90
G