Table of Contents
Advertisement
3. ISDN cables
• Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. Your main
number will be the number associated with the socket to which ISDN cable number 1 is connected.
NOTE
S
OME SOFTWARE VERSIONS DO NOT SUPPORT THREE
North America: The TANDBERG 550 does not have a built-in network terminator. If your wall socket provides you with
an ISDN U-interface, you will need an NT1 between your TANDBERG 550 and your ISDN line, see Appendix 1.
NOTE
W
RITE DOWN THE NUMBERS ASSOCIATED WITH EACH OF THE
C
S
NOTE
ONNECTING TO THE
TANDBERG 550. P
ON THE
4. Power cable
• Connect the power supply to the 'DC in' input on the system.
• Connect the power cable to the power supply.
• Connect the power cable to an electrical distribution socket.
5a. LAN cable
• To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on the system to your LAN.
5b. Wireless LAN - Insert PC Card
• Remove the "dummy" card by pressing the 'Eject' button next to the slot.
• Insert the Wireless LAN PC Card.
M
NOTE
AKE SURE YOU INSERT THE CARD IN THE RIGHT DIRECTION
'E
'
THE
JECT
BUTTON POPS UP
See 'Wireless LAN Settings' for configuration.
TANDBERG Videoconferencing System
ISDN
56
: W
WITCHED
NETWORK
HEN CONNECTING TO THE
A
LEASE REFER TO
PPENDIX
.
LINES
ISDN
. Y
LINES
OU WILL NEED THEM LATER TO CONFIGURE THE SYSTEM
S
56
WITCHED
2
.
FOR FURTHER INFORMATION
(
WITH THE PRODUCT LOGO POINTING UPWARDS
13
NETWORK YOU MAY USE ONE OF THE
). P
USH THE CARD INTO THE SLOT UNTIL
Installation
.
BRI
INTERFACES
Advertisement
Table of Contents
