TANDBERG D12155-10 User Manual page 42

General use
Adding an extra site - dial in
To dial in to the MultiSite on ISDN-BRI:
• Site 2 must dial MultiSite Number 2.
• Site 3 must dial MultiSite Number 3.
To dial in to the MultiSite on ISDN-PRI:
• Dial the main number of the system ('My ISDN Number'). All sites can dial the same number.
To dial in to the MultiSite on IP:
• Dial the IP Number or the IP Address of the system ('My IP Number'/'My IP Address').
When the MultiSite receives an incoming call, the following menu is displayed:
• Pressing C is equivalent to pressing 'Accept'.
ONNECT
• Pressing D is equivalent to pressing 'Reject'.
ISCONNECT
• Pressing 'Do Not Disturb' will disable the MultiSite from answering more incoming calls during the current
conference. The calling party will receive a busy signal.
Disconnecting sites from a conference
disconnect
To disconnect a site or end the conference, press D
• Select site and press O
To end the meeting press 'Disconnect All'.
TANDBERG Videoconferencing System
or 'Disconnect Site'.
K
42
T
O FIND THE DIAL
TIP
'M
PRESS ENU
.
ISCONNECT
E
ACH SYSTEM WILL BE IDENTIFIED BY A
NOTE
S
YSTEM
NUMBER OF THE FAR END
- M S
IN NUMBERS FOR THE ULTI
' 'S I '
AND YSTEM NFO
N ( )
AME IF SUPPORTED AND THE
.
,
ITE