Omron Total Power + Heat PM800 Instruction Manual page 14

2.2 Assembling Steps
1
Prepare pads.
Attach the cord plug into the bottom left side of the device. Place the pads (dark side up) onto a
flat surface.
Note: Do not turn the power on before placing the pads on the body.
CAUTION
• Before use, inspect the cord with pads for open wires or any damage. If damaged, DO NOT use and
replace immediately. The damaged cord with pads may cause skin burns or a fire.
2
Assemble gels.
For first time use, remove the gels from the sealed plastic bag.
Note: The pads and the gels must be used together for safety and effectiveness.
Clean and dry affected area so it's free of all lotions/oils/sweat.
3
Place gels onto the pads.
Each gel has two plastic films. Remove the non-printed side of plastic films and place gels squarely
onto the dark side of the pads.
Make sure the gel lays evenly and securely with no bubbles, bending or missing pieces. Check for
damage and check the adhesion before each therapy session.
The "SKIN" printed side of plastic films are on top.
2. PREPARATION
14