TANDBERG 700 MXP User Manual page 26

TANDBERG 7000 MXP
The bolts on the bottom of the monitor frame (front) shall go through the top plate of the base.
Secure the monitor frame to the base with 2 hexagonal-shaped screws as shown in figure 4, and
with 2 nuts inside the front panel of the base as shown in figure 5.
Figure 5
Figure 4
4 Monitor back cover
Make sure that all cables are connected (se chapter 2.2 Connecting cables) and then lead them
down through the cable duct on the back side of the column. Slide the duct cover of the column
into place. Make sure that all cables come out at the bottom of the column without being
squeezed by the duct cover.
The monitor back cover is kept in place by magnets. Place the cover against the magnetic points
on the monitor frame as shown in figure 7. The front cover if the monitor frame is made of plastic
and should be treated with care.
12